BIG THINGY

How cool is this photo! n4rkla took it while he was high on catalyst.

I can't believe how short the runway is.

GET OUT OF MY LIFE!

N4rkla! Get out of my bloog. I know I hate it but its mine so you must go. Get your pwn perv3rted b1oog. 1 4m h4pp1ly cyn1c4l, grµmp¥ 4nd 133t fre3.

My cut file wasn't b0n3dz0r3d! And stop attracting b0n3r p1r4t3s!

I had done all of my parts and nestings based on 5mm separation between parts (N4rkla the optimist told me ATL have a laz0r cutt0r). A typical, n00bish mistake, but it is all N4rkla's fault. I hate N4rkla.

ATL could only cut the composite panels with a 20mm router bit! That is the hugest router bit ever! And the best for the MDF was 10mm

So I needed to renest everything and modify all of the internal corners on the panels. There is now so much wastage - I did have some nice large panels of carbon and MDF left over and now there all gone - turned into wastage. No more nice carbon sandwich cradle either!

But it should still be ready tomorrow. I can't wait to see it.

Cut Files Bon3d!

Cut-files have been re-issued due to problems. I should have a flat pack moth by the end of my life. My alter ego, markla, is a n00b sometimes.

Panel laminates are:
200DB Carbon/5mm Corecell/200DB Carbon (DB is +-45 degrees)

n4rkla loves you all (and himself)

n4rkla loves blooging, he'd do it all day long if it didn't send him blind...

Cut Files Dispatched

Cut files are now in the hands of ATL.
I should have a flat pack moth by the end of the week.
The one on the left is the hull, and right is the jig.

Hull is two sheets 3400x1200 carbon panel, jig is two sheets 2400x1200 mdf.

Markla Hates You All

And especially hates blogs.
I hate the idea of blogs, I hate reading blogs and I especially hate writing blogs.

I am only doing this because I am under duress and it is easier than doing a website.
Don't expect to see any updates any time soon.